![solidworks 2012 1 link solidworks 2012 1 link](https://i.all3dp.com/cdn-cgi/image/fit=cover,w=675,h=675,gravity=0.5x0.5,format=auto/wp-content/uploads/2020/01/16153802/solidworks-and-inventor-are-3d-modeling-software-w-autodesk-191223.png)
![solidworks 2012 1 link solidworks 2012 1 link](https://www.openbom.com/wp-content/uploads/2019/09/openbom-for-solidworks.jpg)
Start by creating a new drawing and choosing a sheet format that closely resembles your sheet size. We also recommend using some of the standard drawing sizes and title blocks that are available so there is no need to start from scratch.
![solidworks 2012 1 link solidworks 2012 1 link](https://i.ytimg.com/vi/-hmaMzX9Ne8/maxresdefault.jpg)
Once you have created your basic DOT template for your drawing, it is time to create the new sheet format that will be used (the DART file).įor drawings, it is much easier to create both the DOT file and the DART file at the same time. Imagine the board and it’s bulls eye as the DOT file, then the DART file get’s placed into it. When referencing the two different file types, it’s helpful to imagine a dart board. sldDRT and is the actual sheet format for any drawing that you may be creating. However if you are putting a SOLIDWORKS drawing template together, then you will need the second component that I refer to as the DART file. If you are creating a template for a SOLIDWORKS part or assembly, then the DOT file should be all that you need. Once saved, you should see your new template file during the template selection when creating a new file. Also notice that the save location will change based on where you have the file template location set up in SOLIDWORKS. prtdot extension, while an assembly and drawing file will have a. The extension is different for each file type, for instance, a SOLIDWORKS part file will have a. Simply open a new document, (you can use an existing template if you would like), modify the options that you would like to change, then go to File > Save As and change the file type to the DOT extension. To create a SOLIDWORKS part or assembly template is easy. This file is where you can configure various settings about the file that will be created, such as the paper size, dimensioning styles, hatch patterns, etc. The first component is what I refer to as the DOT file, and is the base template that you will use for your files. I would like to take some time to explain how the main components work together and show some best practices for creating and configuring your SOLIDWORKS templates. The process of creating a SOLIDWORKS drawing template seems to be very lacking in the amount of training resources available.